You have either ordered the OEM replacement or aftermarket table adapters (clips) and you are ready to install them.
What's in the box
You should have received:
- 4 × M4 × 18mm screws
- 4 × M4 washers
- 4 × M4 nuts
- 4 × Adapters (clips)
- 1 × Nut insert tool
Installation
Much like the original accessory, this installs on the underside of the spare tire cover. Remove the cover and flip it over to show the anchor points. Assuming you did not have the original kit, you will find 4 mounting points near the inside corners of the cover.
Orientation — OEM replacement clips
Orientation of the adapters won't completely matter with the reproduction of the OEM clips. However, I did design them to align flush with the design of the cover.
Orientation — aftermarket adapters
Orientation will matter for the aftermarket adapters. You should be supplied with 2 versions of the clips — one is just a mirror of the other. Because the legs are slightly offset, the mounting point is not perfectly centered.
When you align the aftermarket adapters, you want the protruding portion to be closest to the center of the cover.